Honda HRN216 Series Manual page 207

TRANSMISSION/DRIVE BELT
VYA TYPE
REMOVAL
1. Drain the fuel tank (P.
2. Disconnect the spark plug cap
3. Fully loosen the Smart Drive cable adjuster.
4. Remove the blades. Use a pair of thick leather gloves to
hold the blades with your hand to prevent the blades
from turning, and then remove the two blade bolts and
special washers.
13-4
3-11) and engine oil (P. 3-6).
(P. 3-8).
JAM NUT
TIGHTEN
ADJUSTER
MARK
UPPER BLADE
LOWER
BLADE
SPECIAL
WASHER (2)
BLADE BOLT (2)
HRN216
LOOSEN