Honda HRN216 Series Manual page 213

TRANSMISSION/DRIVE BELT
TRANSMISSION
DRIVE BELT
5 x 16 mm FLANGE BOLT (4)
8.8 ~ 11.8 N•m (6.5 ~ 8.7 ft-lb)
CASE COVER
12.7 x 22.2 x 6.4 mm
OIL SEAL (2)
RING GEAR
* TRANSMISSION CASE
OIL REFILL: P. 2-20
Use SAE 10W-30 SN engine oil
and fill to the capacity specified.
CAPACITY: 44 cc (1.5 oz)
13-10
10 mm FLANGE NUT
27 N•m (20 ft-lb)
12 x 28 x 6 mm OIL
SEAL
BELT GUIDE
CASE O-RING
12.7 mm PLAIN
WASHER (2)
12.7 mm PLAIN
WASHER (2)
6001 BALL
BEARING
DOWEL
PINS (2)
FINAL SHAFT
12.7 mm OUTER
CIRCLIP
HRN216
DRIVEN PULLEY HALVES
REMOVAL
Hold the pinion shaft with
a wrench, and then
remove the 10 mm flange
nut.
INSTALLATION:
Align the pulley pins
opposite each other so
that they fit into the small
holes of the other pulley
half.
10 x 24 mm
HARDENED
WASHER
28 mm INNER
CIRCLIP
PINION SHAFT
6 x 14 mm
FLANGE BOLT (2)
RETURN
SPRING
TRANSMISSION
CASE*
TRANSMISSION
6 x 14 mm
STAY
FLANGE
BOLT (2)