Honda HRN216 Series Manual page 134

HRN216
8. Remove the flywheel
PKA/VKA/VLA types only:
Pull the flywheel brake lever and secure the lever to the
handlebar with a strap or equivalent material. This allows
the flywheel and crankshaft to turn.
Holding the flywheel with the flywheel holder special tool
or a commercially available strap wrench, remove the
14 mm special nut.
TOOLS:
FLYWHEEL HOLDER
Note: Ignition coil removal my be required when using a
strap wrench and/or puller.
Position a commercially available 2-jaw flywheel puller on
the flywheel with one of the puller jaws under the magnets
(at the PULLER marks).
Set a shop towel or equivalent cloth between the flywheel
and puller.
Tighten the flywheel puller until snug and then tap the end
of the puller with a heavy brass hammer to release the
flywheel.
NOTICE
Do not use an impact wrench when removing the
flywheel. The flywheel may be likely to break if too much
force is applied.
(P. 9-8).
07APB-Z28A101
CAMSHAFT/CRANKSHAFT/ PISTON/CYLINDER
SHOP TOWEL

SPECIAL
NUT,
FLYWHEEL
14 mm
HOLDER
BRASS HAMMER
FLYWHEEL
PULLER, OTC-1035
(commercially
available)
10-11