Honda HRN216 Series Manual page 138

HRN216
11. VLA type only:
Reinstall the electric starter motor
the two 6 mm bolts to the specified torque.
TORQUE: 11 N•m (97 in•lb)
Reconnect the battery charger connector on the
handlebar.
12. VYA type only:
Reinstall the drive pulley and drive belt.
Check the bearing in the blade holder to ensure it rotates
smoothly, and does not bind or feel rough or gritty. It is
recommended to replace this bearing if the crankshaft is
being replaced due to impact damage.
Install the Roto-Stop assembly following the instructions
starting on P. 4-11.
13. Install the fan cover and tighten the five 6 x 23 mm bolts
to the specified torque
TORQUE: 12 N•m (9 ft-lb)
14. Install the top cover and spring nut, and then tighten the
5 x 8 mm screw to secure the top cover in place
TORQUE: 1 N•m (8.8 in•lb)
Reinstall the fuel tank cap.
(P. 9-12) and tighten
(P. 7-3).
CAMSHAFT/CRANKSHAFT/ PISTON/CYLINDER
6 mm SPECIAL BOLT (2)
11 N•m (97 in•lb)
STARTER MOTOR
CLUTCH SPRING
10 x 24 mm
SPECIAL HEX
BOLT
(P. 7-1).
TOP
COVER
DRIVE PULLEY/BELT
BRAKE
ASSEMBLY
DRIVE DISK
DRIVEN DISK
BLADE HOLDER
6 x 23 mm
BOLT (5)
FAN
COVER
SPRING
NUT
5 x 7 mm
SCREW
10-15