Honda HRN216 Series Manual page 66

HRN216
REMOVAL
1. Disconnect the spark plug cap.
2. Turn the fuel valve to the OFF position, and tilt the
mower on its side so the carburetor is up.
3. Use a pair of thick leather gloves to hold the blades with
your hand to prevent the blades from turning. First,
loosen the center 3/8-24 x 1 inch special bolt leaving the
blade holder still on the crankshaft, and then loosen the
two blade bolts (P. 4-4). Using this method prevents the
need to hold the flywheel or flywheel nut when loosing
the blade holder bolt.
4. Remove the blade holder by pulling it off of the
crankshaft.
5. Remove the Woodruff key from the slot in the crankshaft.
6. Remove the two 6 x 14 mm flange bolts and the belt
guide.
7. Slide the drive pulley away from the engine and remove
the V-belt from the drive pulley.
INSTALLATION
Install in the reverse order of removal.
Adjust the belt guide (P. 2-19).
Be sure the Woodruff key is installed in the slot closest to the
end of the crankshaft, and that it does not dislodge when
installing the blade holder. Failure to do so will result in blade
holder bolt failure that can cause the blade holder to come
off.
Hand tighten the 3/8-24 x 1 inch special bolt and two blade
bolts. Use a pair of thick leather gloves to hold the blades
with your hand to prevent the blades from turning and then
tighten all three bolts to the specified torque.
TORQUE: 54 N•m (40 ft-lb)
BLADE HOLDER/ROTO-STOP®
WOODRUFF KEY
BLADE HOLDER
3/8-24 x 1 in
SPECIAL BOLT
54 N•m (40 ft-lb)
BELT GUIDE
DRIVE
PULLEY
6 x 14 mm FLANGE BOLT
DRIVE BELT
4-5