Antenna - HP Slate 10 Plus Maintenance And Service Manual

Antenna

Description
Antenna (includes double-sided adhesive)
Before removing the antenna, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the display panel assembly (see
Remove the antenna:
CAUTION:
is clear of tools, screws, and any other foreign objects. Failure to follow this caution can result in
damage to the display panel.
1.
Position the tablet with the display panel facing up and the SD Card Reader/SIM slot cover
toward you.
2. Release the ZIF connector (1) to which the antenna cable is attached, and then disconnect the
antenna cable from the display panel assembly.
3. Detach the antenna transceiver (2) from the display panel assembly. (The antenna transceiver is
attached to the display panel assembly with double-sided adhesive.)
4.
Remove the antenna.
Reverse this procedure to install the antenna.
18 Chapter 5 Removal and replacement procedures
Before positioning the tablet with display panel facing down, make sure the work surface
Display panel assembly on page
Spare part number
776022-001
15).