Table of Contents
Advertisement
When the Following Screen is Displayed
Dark Calibration Position
Confirmation Screen
Dark Calibration
failure Screen
NOTE
● Dark calibration can be done by turning the
Light Selection Ring
calibration position
Screen.
● Dark calibration is performed when new
batteries are sed, 24 hours passed since last
use or there is a big change in temperature
between turning power OFF and ON again.
Except the cases above, dark calibration after
power ON is skipped.
The Light Selection Ring
(
) or Range L
calibration could not be performed.
Set the Light Selection Ring
position
(
Dark calibration was performed, but it could not be
completed normally.
Set the Light Selection Ring
position
(
calibration again.
to set to the dark
2
(
) in Measuring
170
7. Meter Settings [Setting] Screen
is set to Range H
2
(
), and dark
to the dark calibration
2
), and perform dark calibration.
to the dark calibration
2
) again, and perform dark
Light Selection Ring
2
Advertisement
Table of Contents
