Table of Contents
Advertisement
NOTE
● Range L
(lower than
Range H.
● Range H
than
0l s) Under will appear if flash power is too low. Select Range L.
8.
Press the Measuring Button 5.
The meter will enter measurement standby mode.
hile the icon is blinking, manually trigger the flash.
The [Measuring Mode] icon will blink for 90 seconds when measuring.
The display illumination will dim when the measuring button is pressed as the display
illumination can affect the reading. This is normal.
When the flash light is fired, the measured value will be displayed for
the display will return to measurement standby mode.
To cancel standby mode, touch the screen or press the Menu Button
NOTE
When the icon stops blinking before triggering the flash, or when you want to
take measurements again, press Measuring Button
Measurement in Cordless Flash Mode is complete.
(
) Select when measuring small and low power flash units
0l s), Over will appear if flash power is too high. Select
(
) Select when measuring powerful flash units (brighter
69
5. Measuring Light Sources [Measurement Screen]
again.
5
seconds, and
.
6
Advertisement
Table of Contents
