Table of Contents
Advertisement
CA T O
●
Depending on the flash e uipment used, the flash may be triggered when the
sync cord is connected to the Sync Terminal
Button
. Because there is the possibility of burns or negative effects on
3
vision, please handle with care.
●
Do not trigger flash while skin or other objects are in contact with the flash
tube. Do not touch the flash tube after continuous flashes. ( t may cause
burns.)
●
Do not trigger flash while near the eyes of people or animals. ( t may
temporarily affect vision.)
●
The flash may be triggered suddenly. Because there is the possibility of
burns or negative effects on vision, please handle with care.
NOTICE
● f the triggering voltage of the flash used is extremely low, the flash may not
trigger. n this care, use "5-3 Measurement in Cordless Flash Mode". ( P66)
●
hen measuring flash bulbs, make sure the shutter sync speed is set to the
proper synchroni ation range of your camera.
NOTE
Over or Under will be displayed if the light source illumination is too bright or not bright
enough, or if the color temperature is out of the measurement range, when the Measuring
Button is pressed.
In this case, adjust the brightness or color temperature of light source, or switch the light
range. ( P 0)
5. Measuring Light Sources [Measurement Screen]
or when operating the Power
b
76
Advertisement
Table of Contents
