Table of Contents
Advertisement
11.
Troubleshooting
The following cases may not suggest failures. Please check again before requesting
repair. When the meter does not function normally after checking the following, it
may be damaged. Remove the battery, and ask the retailer or us to repair it.
Status
It does not turn on
(It does not display)
The LCD does not
respond
The measurement cannot
be made
The measured values are
wrong
Check item
Are you pressing and holding the
Power Button for one or more
seconds?
Are
of the batteries inserted
properly?
Is there enough battery?
Are the battery terminals dirty?
Are you using the specified
batteries?
Is the screen locked?
Are you using the "C-700 Series
Utility"?
Is the Light Selection Ring in
the middle position? The light
distribution characteristics
change and suitable
measurements cannot be made.
Are any unnecessary corrections
or filter corrections set
Is the measuring mode wrong?
(Such as measuring in Ambient
Light Mode in flash light)
Are you using the pre-flash
function when measuring in
Cordless Flash Mode?
198
11. Troubleshooting
Measure
Press and hold the Power Button
for one or more seconds.
Check the
signs. ( P4)
Replace the battery. ( P9)
Wipe them off with a dry cloth.
Check the batteries. ( P4)
Press and hold the Menu
Button
to unlock the screen.
6
( P21)
Stop using the "C-700 Series
Utility".
Rotate the Light Selection Ring
until it clicks.
Check the Target (reference
color temperature) to see if the
setting is wrong. ( P26)
Check the Preset Target Color
Temperature and confirm the
setting is correct. ( P161)
Check if the measuring mode is
correct. ( P22)
In Cordless Flash Mode, the
measurement value of the main
flash may not be displayed
because the pre-flash is
measured at first.
Cancel the pre-flash function.
Advertisement
Table of Contents
