2-2
Installing the Batteries
1.
Prepare two AA batteries.
2.
Slide the Battery Cover atch
remove the Battery Cover 9.
3.
Insert the batteries according to the "+" and "-" symbols in the
Battery Compartment d.
* As shown in the diagram below, please note both positive sides of the batteries are
facing in the same direction.
4.
hile lining up the two tabs on the Battery Cover 9, press the
Battery Cover
Battery Cover
9
Battery Compartment
WARNING
Do not place batteries in open flames, attempt to short, disassemble, apply
heat to, or recharge them (except rechargeable batteries). They may burst and
cause fires, serious injury, or damage to the environment.
CAUTION
●
Please insert the batteries minus "-" side first.
hen removing the batteries, remove them plus " " side first.
●
Do not use batteries with any other rating than the one specified.
Also, do not mix old and new batteries.
●
lf the meter will not be used for an extended period of time,
it is recommended to remove the batteries to avoid possible damage caused
by battery leaking.
8
9
back into place from above.
Battery Cover Latch
d
4
in the direction of the arrow and
Tabs
8
2. Before Use