Table of Contents
Advertisement
NOTICE
● Select a shutter speed that will synchroni e with your camera and
flash system.
● f the triggering voltage of the flash used is extremely low, the flash
may not trigger. n this case, use "5-3 Measurement in Cordless Flash
Mode". ( P66)
8.
Confirm the light measuring range.
When you return to the Measurement screen,
select Range L
depending on the brightness of the flash.
NOTE
● Range L
units (lower than
Select Range H.
● Range H
than
0l s) Under will appear if flash power is too low. Select Range L.
9.
Press the Measuring Button 5.
Measurement will be taken with flash, and the light source values will be
displayed.
Because it affects measurement while measuring, the LCD backlight will dim. It is not a
defect.
Measurement in Cord (PC) lash Mode is complete.
(
) or Range H
(
) Select this when measuring small and low power flash
0l s), Over will appear if flash power is too high.
(
) Select when measuring powerful flash units (brighter
75
5. Measuring Light Sources [Measurement Screen]
Light Selection Ring
Range H
(
)
Range L
Measuring Button
2
5
Advertisement
Table of Contents
