Table of Contents
Advertisement
5-7
hen [Over], [ nder] or [ ilter
When Over or Under is displayed, measurement cannot be taken.
When
ilter N/A is displayed, the indicated value is out of display while
measurement can be taken.
5-7-1
Display of [Over], [ nder] or [ ilter
hen [Over] is displayed
If the indicated values are higher than the ma imum measuring
range, Over is displayed.
When measuring ambient light, decrease the brightness of the
illumination.
When measuring flash light, turn the Light Selection Ring
and change the range from L
lower the flash output power.
When [Under] is displayed:
If the indicated values are lower than the minimum measuring
range, Under is displayed.
When measuring ambient light, increase the brightness of the
illumination.
When measuring flash light, turn the Light Selection Ring
and change the range from H
raise the flash output power.
hen [ ilter
A] is displayed
If
ilter N/A appears in the filter number indication, it is out of
display range (combination) of filter number.
Take a new measurement after changing the target color
temperature.
NOTE
Measurements and display will take longer in light levels below 0l . The LCD illumination
will normally switch off during measurements to avoid influence to measurements.
5. Measuring Light Sources [Measurement Screen]
(
) to H
(
(
) to L
(
88
A] is Displayed
A]
Light Selection Ring
,
2
), or
Measuring Button
,
2
), or
2
5
Advertisement
Table of Contents
