6.
Confirm the light measuring range.
When you return to the Measurement screen, make
sure to select Range L
7.
Press the Measuring Button 5.
Measurement will be taken and the light source
values will be displayed.
hile the button is held, the meter measures
continuously.
hen the button is released, the measurements
will stop and the light source value at the time of
release will be displayed.
NOTE
● Over or Under will be displayed if the light source illumination is too bright
or not bright enough, or if the color temperature is out of the measurement
range, when the Measuring Button is pressed.
In this case, adjust the brightness or color temperature of light source.
● Measurements and display will take longer in light levels below 0l . The
LCD illumination will normally switch off during measurements to avoid
influence to measurements.
Measurement in Ambient ight Mode is complete.
5. Measuring Light Sources [Measurement Screen]
(
).
65
Light Selection Ring
Range L
Measuring Button
2
5