Instructions For Installing The Total Access 850 Controller And Access Modules; Module Shipping Contents; Quad Fxo Access Module (P/N 1175407L2); Quad Fxs Access Module (P/N 1175408L2) - ADTRAN Total Access 850 System Manual

Section 3 Network Turnup Procedure
3. Align the card edges to the guide grooves and insert the unit until the edge connector seats firmly
into the backplane.
4. Lock the card in place by pushing in on the lock lever.
5. Reinstall the card-lock safety bar.

Instructions for Installing the Total Access 850 Controller and Access Modules

Individual access modules insert from the front. A locking bar holds the modules in place for added
security. Disengaging the captured screw allows removal of the locking bar. To install Controller Resource
and Access Modules for the Total Access 850, follow the steps outlined below.
1. Hold the access module by the faceplate while supporting the bottom side.
2. Align the module edges to the guide grooves for the designated slot.
3. Insert the module until the edge connector seats firmly into the backplane.
4. Lock the module in place by pushing in on the locking lever.
5. Connect the cables to the associated device(s). All wiring connections terminate on the backplane
of the chassis.
9.

MODULE SHIPPING CONTENTS

Quad FXO Access Module (P/N 1175407L2)

Shipping Contents
The ADTRAN shipment of the Quad FXO Access Module includes the following:
• Quad FXO Access Module

Quad FXS Access Module (P/N 1175408L2)

Shipping Contents
The ADTRAN shipment of the Quad FXS Access Module includes the following:
• Quad FXS Access Module

UBR1TE Access Module (P/N 1180020L1)

Shipping Contents
The ADTRAN shipment of the UBR1TE Access Module includes the following items:
• UBR1TE Access Module
• UBR1TE Access Module Job Aid
62 © 2004 ADTRAN, Inc.
Total Access 850 System Manual
64203376L1-1B