Tools Required; Unpack And Inspect The System - ADTRAN Total Access 850 System Manual

Section 3 Network Turnup Procedure
1. INTRODUCTION
This section discusses Total Access 850 installation.
2.

TOOLS REQUIRED

The tools required for wallmount installation of the Total Access 850 shelf are:
• Four #8 x 3/4 inch pan-head wood screws
• Drill and drill bit set
• Flat head screwdriver (medium)
• Two Phillips head screwdrivers (small/medium)
• Wire-wrap gun (optional)
• 5-pair male amphenol cable (customer connection)
• Selected punch-down block and tool
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
During installation, power should be the last connection made.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
3.

UNPACK AND INSPECT THE SYSTEM

Each Total Access 850 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier, and then contact ADTRAN Customer Service (see
Customer Service, Product Support Information, and Training in the front of this manual).
56 © 2004 ADTRAN, Inc.
Total Access 850 System Manual
64203376L1-1B