ADTRAN Total Access 850 System Manual page 197

Total Access 850 System Manual
This line code must match the line code used by the other units in the network.
Set the E
5
sufficient.
Set the CSU L
6
whether looping to this unit from another unit will be allowed.
Step
1 From the main menu, select I
Highlight the C
2
Right arrow to select F
3
This
DSX-1 interface. A
condition.
4 Set the L
This line code must match the line code used by the equipment connected to
the DSX-1 interface.
Set the E
5
sufficient.
Set the CSU L
6
whether looping to this unit from another unit will be allowed.
2. Mapping the DS0s
For more details on the configuration parameters discussed in this section, refer to the following pages:
DS0 Map menus beginning on
64203376L1-1B
T1 Interface Setup Instructions (Continued)
or line build out. The default setting of 0
QUALIZATION
option to E
PBK
DSX-1 Interface Setup Instructions
menu for the DSX interface and press <E
ONFIG
ORMAT
F must match the format used by the equipment connected to the
ORMAT
F
ORMAT
C to B8ZS or AMI.
INE ODE
or line build out. The default setting of 0
QUALIZATION
option to E
PBK
page 180
© 2004 ADTRAN, Inc.
, D , or D
NABLE ISABLE ISABLE
Action
.
NTERFACES
and choose ESF or SF.
mismatch normally results in a Red Alarm
, D , or D
NABLE ISABLE ISABLE
Section 4 User Interface Guide
B is usually
D
A based on
LL
>.
NTER
B is usually
D
A based on
LL
197