ADTRAN Total Access 850 System Manual page 207

Total Access 850 System Manual
3. Setting the Router Options
For more details on the configuration parameters discussed in this section, refer to the following pages:
Router Ethernet Interface Configuration menus beginning on
Router Network Interface Configuration menus beginning on
Router Default Gateway menus beginning on
Step
1 From the main menu, select R
2 Use the right arrow key to highlight C
Select I
3
S
ETUP
4 Highlight the P
5 Set the IP A
6 Set the S
By default, RIP is disabled on the Ethernet interface. If RIP needs to be
enabled, highlight the RIP field and press <E
7 V
ERSION
configure RIP on the interface. For more details, refer to Router > Config >
Interfaces (ETH) > Sub-Interface on page 148.
Press the left arrow key to return to the Ethernet sub-interface menu (displays
8
P
RIMARY
If your application requires additional secondary IP address, highlight the
S
ECONDARY
5 additional LAN segments. Enter each additional secondary IP address and
9
corresponding subnet mask. To add a new IP address entry, highlight the N
field and press the <I> key. To delete an existing entry, highlight the N
for the entry to delete and press the <D> key.
10 Left arrow back to the main menu to save the changes.
Step
1 From the main menu, select R
2 Use the right arrow key to highlight C
64203376L1-1B
Router Options – Ethernet Interface
and press <E
NTERFACES
field for the ETH (Ethernet) interface and press <E
IP field and press <E
RIMARY
of the Ethernet port.
DDRESS
M for the Ethernet port.
UBNET ASK
, RIP M , D
ETHOD IRECTION
IP and S IP).
ECONDARY
IP field and press <E
Router Options – T1 Interface (L2 Protocol = ATM)
© 2004 ADTRAN, Inc.
page 148
page 148
page 157
Action
and press <E
OUTER NTER
and press <E
ONFIG
>. Use the right arrow key to highlight the
NTER
>.
NTER
>. Set the appropriate
NTER
, and V2 S (where applicable) to
ECRET
>. The Total Access 850 supports up to
NTER
Action
and press <E
OUTER NTER
and press <E
ONFIG
Section 4 User Interface Guide
>.
>.
NTER
>.
NTER
UM
field
UM
>.
>.
NTER
207