ADTRAN Total Access 850 System Manual page 140

Section 4 User Interface Guide
L2 P (T1 ATM–T1–C
ROTOCOL
Configure the
L2 P
ROTOCOL
To insert a new profile, press the
will always be set up with the default parameters. To copy parameters from an old profile
to this newly inserted profile, use the copy (
trees can be copied with this method.
To delete an unused profile, use the
column. Once deleted, the profile is gone permanently.
L2 P (T1 ATM–T1–C
ROTOCOL
Displays the index number in the DLCI config table. The number range is
L2 P (T1 ATM–T1–C
ROTOCOL
When this parameter is set to
the unit will ignore the virtual circuit with this DLCI.
L2 P (T1 ATM–T1–C
ROTOCOL
Shows the user the physical and logical port associated with each DLCI. This is a read-only field.
L2 P (T1 ATM–T1–C
ROTOCOL
The DLCI (Data Link Connection Identifier) number identifies the virtual circuit being configured. The
DLCI range is
16-1023
L2 P (T1 ATM–T1–C
ROTOCOL
Select the physical and logical method of data transfer over the virtual path. There are two valid connection
entries: R and V
OUTER OICE
integral IP router. Select
interface).
L2 P (T1 ATM–T1–C
ROTOCOL
This submenu only appears for
this menu.
L2 P (T1 ATM–T1–C
ROTOCOL
The setting is used to configure the correct Voice Gateway protocol for voice signaling
C C
ALL ONTROL
control between the Total Access 850 and the configured Gateway. The Call Control setting must be
configured correctly before the voice circuits will work correctly. The Total Access 850 supports
J , C
ETSTREAM OPPERCOM
140
MTN) > C
U
parameters for the T1 interface using Copper Mountain Frame Relay protocol.
MTN) > C
U
MTN) > C
U
(def), the mapping is used to determine the protocols used. If set to
Y
ES
MTN) > C
U
MTN) > C
U
. The default is corresponding to the index numbers
16-25
MTN) > C
U
. Select R to connect traffic from this PVC to the Total Access 850
OUTER
V to connect traffic from this PVC to a voice connection (normally an FXS
OICE
MTN) > C
U
connections. Configure the
V
OICE
MTN) > C
U
, T and LES-CAS
OLLBRIDGE
© 2004 ADTRAN, Inc.
ONFIG
key when over the
I N
UM
) and paste (
C
key when the cursor is over the number in the
D
> N
ONFIG UM
> A
ONFIG CTIVE
> I
ONFIG NTERFACE
> DLCI
ONFIG
> C
ONFIG ONNECTION
> S
ONFIG ETUP
C C
ALL
> S > C
ONFIG ETUP
(def).
Total Access 850 System Manual
column. A new inserted profile
) keys. Entire configuration
P
.
0-9
respectfully.
0-9
for voice gateway using
ONTROL
C
ALL ONTROL
64203376L1-1B
N
UM
N ,
O