ADTRAN Total Access 850 System Manual page 220

Section 5 DLP-3
Perform the steps below in the order listed.
1. Connect the Total Access 850 unit to your VT100 system (details found in DLP-1, Connecting a VT100
Terminal or PC to the CRAFT Port).
2. Log in to the system.
3. From the R /C
OUTER
4. Select S for the ETH interface, then P
ETUP
5. Highlight the IP A
DDRESS
system administrator).
6. Highlight the S
UBNET
your system administrator).
7. Highlight the D
EFAULT
given by your system administrator).
8. Press the left arrow key to highlight the P
requires confirmation.
9. Escape out to the R
220
menu, select the I
ONFIG
RIMARY
field and press <Enter>. Enter the appropriate IP address (as given by your
M field and press <Enter>. Enter the appropriate subnet mask (as given by
ASK
G field and press <Enter>. Enter the appropriate default gateway (as
ATEWAY
RIMARY
menu and log off by pressing <CTRL+L>.
OUTER
© 2004 ADTRAN, Inc.
option and press <Enter>.
NTERFACES
IP.
IP submenu. This action saves your changes and
Total Access 850 System Manual
64203376L1-1B