ADTRAN Total Access 850 System Manual page 206

Section 4 User Interface Guide
2. Configuring the Layer 2 Protocol
.
For more details on the configuration parameters discussed in this section, refer to the following pages:
Layer 2 ATM Network Interface Protocol menus beginning on
Step
1 From the main menu, select L2 P
Use the arrow keys to select the P
2
<E
NTER
Use the arrow keys to select the C
3
<E
NTER
4 Highlight the ATM C
5 Enter the I
6 Set D
Back all the way out to one level to the PVC C
7 Enter the VPI and VCI values for communicating with that Gateway. Select
R
OUTER
Select the S
8 (Our example selects IP.) Refer to L2 Protocol (T1 ATM–T1–ATM) > Config >
PVC Config > Connection on page 131 for more details.
Set mode to R
IP packets and bridge all other data packets (R
9 bridge all data packets on this connection (B
(T1 ATM–T1–ATM) > Config > PVC Config > Setup (Router) on page 131 for
more details.
10 Left arrow back to the main menu to save the changes.
206
Layer 2 Protocol (ATM) Configuration – T1 Interface
>. Select ATM from the list of available protocols.
>.
menu for the T1 interface and press <E
ONFIG
C format for your network.
DLE ELLS
S appropriately for your network.
ATA CRAMBLING
under the C
ONNECTION
menu and configure the virtual circuit for IP or PPP operation.
ETUP
IP. Using this menu you also have the option to route only
OUTE
© 2004 ADTRAN, Inc.
Total Access 850 System Manual
page 129
Action
and press <E
ROTOCOL
field for the T1 interface. Press
ROTOCOL
menu for the T1 interface and press
ONFIG
menu, and press <E
ONFIG
field.
IP/B
OUTE
A ). Refer to L2 Protocol
RIDGE LL
>.
NTER
>.
NTER
>.
NTER
O ) or
RIDGE THER
64203376L1-1B