ADTRAN Total Access 850 System Manual page 157

Total Access 850 System Manual
M
ETHOD
Specifies the way the RIP protocol sends out its advertisements. The following options are
available:
S H
PLIT ORIZON
(Default) Only routes not learned from this circuit are advertised.
P R
OISON EVERSE
All routes are advertised, but the routes learned from this point are "poisoned" with an
infinite metric.
D
IRECTION
Allows the direction at which RIP advertisements are sent and received to be specified.
R > C > R
OUTER ONFIG
Configures the default gateway and static routes from this menu.
R > C > R
OUTER ONFIG
The default gateway is used by the unit to send IP packets whose destination addresses are not found in the
route table (otherwise known as the gateway of last resort). Default is
the entire unit, not just for the Ethernet port.
R > C > R
OUTER ONFIG
Use this menu to enter static routes to other networks.
N
UM
Displays the index number in the static route table.
A
CTIVE
Adds this static route entry to the IP routing table when set to
added) if set to
N
O
IP A
DDRESS
The IP address of the host or network address of the device being routed to. Default is
S M
UBNET ASK
Determines the bits in the previous IP address that are used. If this is to be a host route, it must be set
to all ones (255.255.255.255). Default is
64203376L1-1B
OUTES
> D
OUTES EFAULT
> S R
OUTES TATIC
. Default is .
N
O
0.0.0.0
© 2004 ADTRAN, Inc.
G
ATEWAY
0.0.0.0.
OUTES
and removes it (if it was previously
Y
ES
.
Section 4 User Interface Guide
This is a default gateway for
0.0.0.0
.
157