Required Tools; Necessary Supplies - ADTRAN Total Access 300 Installation And Maintenance Practice

Required Tools

Standard technician tools are used for a ONT installation (for example, drill, drill bits, side
cutters, screwdrivers, nut drivers, hex wrenches, wire strippers, side cutters, etc.).
Additionally, the following tools maybe required for the installation of the ONT:
• Carpenter's level
• 3/32" screw driver (refer to the
• Fiber splicing tools
• RJ45/RJ11connector crimper
• A telephony/data communication test set
• PON power meter preferably with wave length filtering
• Fiberscope or videoscope
• Optical Time Domain Reflector meter calibrated for 1310 and 1550nm output
• Opti-tap Drop Cable of sufficient length to extend from the Local Convergence Point (LCP)
to the ONT (connectorized installation)
• Composite fiber cable for non-connectorized installation
• ONT mounting hardware
• Silicone sealant (and application material, i.e., cotton swabs)
• Bonding clamp for grounding and securing the composite cable on non-connectorized
installations
• 1 each, 60" Hi-cap riser pipe (for composite cable installation)
• Tie wraps
• TexWipe TM Alco pad for fiber cleaning
• TexWipe TM cloth for fiber cleaning

Necessary Supplies

The unit packaging contains IDC terminals, fiber cable management and strain relief, fiber
connector or splice holds, and electronics/optics. The SFU provides one RJ45 connector for
the Ethernet port. For POTS connections the SFU may be connected using either the
Insulation Displacement Connectors (IDC) or RJ11connectors.
Make sure you have access to the following supplies:
• Three #10 screws and appropriate surface anchors for mounting the ONT
• Assorted tie wraps for securing cabling and wiring
• One RJ45 plug and two RJ11 Plugs if not using IDC wiring option
• SC/APC fiber connectors
61187602G2-5A
"ONT Power Connector" on page 31)
Installation
19