Mounting The Merlin Mail-Ml Unit - AT&T MERLIN MAIL System Programming And Maintenance Manual

Installation
Mounting the MERLIN MAIL—ML Unit
Refer to Figures 2-3 and 2-4 as you follow the instructions for mounting the
MERLIN MAIL—ML unit below:
1. Remove the wall mount and cable manager bracket from the shipment
package.
2. Position this bracket so that the slot is upward and use the bracket as a
template to mark the four points on the plywood surface or wall studs
where the wall-mounting screws will be inserted.
WARNING:
Be sure to install the wall-mounting screws in wall studs or in a
piece of plywood to ensure permanent mounting and to prevent
wall damage.
3. Secure the wall mount and cable manager bracket as shown in
Figure 2-3.
For mounting on plywood, use the four #8 X 3/4-inch pan-head sheet
metal screws provided (or their equivalent). For mounting to wall studs
through drywall, use four #8 x 1 1/4-inch (or longer) pan-head sheet
metal screws.
4. From the rear panel of the MERLIN MAIL—ML cabinet, remove the #6-32
hex-head screw from the mounting hole on the lower right. (See Figure
2-4 for position of screw.)
Installing the MERLIN MAIL—ML Unit
2-7