JA2500 Junos Space Appliance Hardware Guide
Configuring a Junos Space Appliance as a Junos Space Node
50
(Optional) IPv6 address for the NAT outbound SSH
(Optional) IPv4 port number for the NAT outbound SSH
(Optional) IPv6 port number for the NAT outbound SSH
(Optional) IPv4 address for the NAT trap
(Optional) IPv6 address for the NAT trap
(Optional) IPv4 port number for the NAT trap
(Optional) IPv6 port number for the NAT trap
This topic discusses the following tasks:
Configuring a Junos Space Appliance as a Junos Space Node on page 50
Configuring Access to Junos Space Through a NAT Gateway on page 64
Configuring the eth1 Interface on page 69
You can configure the Junos Space Appliance as a Junos Space node.
To configure a Junos Space Appliance as a Junos Space node:
At the serial console login prompt, type the default username (
1.
Type the default password (
2.
You are prompted to change your password.
To change the default password, do the following:
3.
Type the default password and press Enter.
a.
Type your new password and press Enter.
b.
Retype your new password and press Enter.
c.
If the password is changed successfully, the message
is displayed.
updated successfully
) and press Enter.
abc123
passwd: all authentication tokens
Copyright © 2018, Juniper Networks, Inc.
) and press Enter.
admin