Applying Or Cancelling Changes To Settings - Juniper JA2500 Junos Space Hardware Manual

Applying or Cancelling Changes to Settings

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
You are taken to a shell where you can run commands. When you are in shell mode,
the prompt is of the format
identifier for the node.
To exit the shell, type
exit
3.
You are taken to the Junos Space Settings Menu.
Changes to the appliance settings are not applied immediately but are queued in the
order that you made the changes. You must explicitly apply the changes before quitting
the Junos Space CLI so that the changes to the appliance settings are made. Alternatively,
you can choose to cancel some or all changes that you made.
To apply all changes or cancel one or more changes, do one of the following:
To apply all changes, type
The changes are applied and you are taken to the Junos Space Settings Menu.
NOTE: For some changes, you may be asked to enter your administrator
password before the change is applied.
To cancel a change, type the number corresponding to that change, and follow the
prompts on the CLI.
To cancel all changes and quit the console session, type
Configuring a Junos Space Appliance as a Junos Space Node on page 48
Configuring a Junos Space Appliance as a Standalone or Primary FMPM Node on
page 70
Configuring a Junos Space Appliance as a Backup or Secondary FMPM Node for High
Availability on page 80
Booting the Junos Space Appliance on page 47
Junos Space Ethernet Interfaces Overview on page 7
NTP Time Source for a Junos Space Appliance on page 11
Chapter 7: Performing Initial Configuration
format, where identifier is a unique
[root@identifier ~]#
and press Enter.
.
A
.
C
95