Changing The Time Zone And Ntp Servers; Retrieving And Transferring System Log Files - Juniper JA2500 Junos Space Hardware Manual

Changing the Time Zone and NTP Servers

Retrieving and Transferring System Log Files

Copyright © 2018, Juniper Networks, Inc.
(Optional) Type the default gateway in dotted decimal notation and press Enter.
6.
The eth1 interface is configured.
To verify the modified IP address of the eth1 interface, run the
7.
and check that the IP address displayed for eth1 is the same as that you modified.
To troubleshoot issues in configuring the eth1 interface, refer to the
file.
/var/log/changeEth1.log
You can change the time zone, add or delete an NTP server, and enable or disable an
NTP server. When you configure each Junos Space Appliance with an NTP server, you
ensure that if the first node, which is used to synchronize time for all nodes in the fabric,
goes down, all other nodes in the fabric remain synchronized. To ensure this behavior,
all nodes in a fabric should be configured with the same external NTP server that you
configured for the first appliance.
To change the time zone and NTP servers for your Junos Space Appliance, do the
following:
On the Junos Space Settings Menu, type
1.
The Change Time Options menu is displayed.
(Optional) To change the time zone, type
2.
(Optional) To modify NTP servers, type
3.
You are taken to the NTP options menu. You can do the following:
Type to disable or enable an NTP server, depending on whether the NTP server is
1
enabled or disabled, and follow the prompts on the CLI.
Type 2 to add an NTP server, and follow the prompts on the CLI.
Type to delete an NTP server, and follow the prompts on the CLI.
3
The option to delete an NTP server is available only if the appliance has two or more
NTP servers already configured.
Type to apply all the changes that you made, or type
4. A
Settings Menu without applying the changes.
You can retrieve system log files using Secure Copy Protocol (SCP) if the network is
functional, or a USB device if the network is down.
NOTE: To save the system log files to a USB device, the device must be
connected to the Junos Space Appliance.
Chapter 7: Performing Initial Configuration
ifconfig eth1
at the prompt.
3
and follow the prompts on the CLI.
1
.
2
to return to the Junos Space
M
command
93