Configuring The Eth1 Interface - Juniper JA2500 Junos Space Hardware Manual

Configuring the eth1 Interface

Copyright © 2018, Juniper Networks, Inc.
To apply the settings, type
series of messages is displayed on the console, and then the Junos Space Settings
Menu is displayed, as follows:
Junos Space Settings Menu
1> Change Password
2> Change Network Settings
3> Change Time Options
4> Retrieve Logs
5> Security
6> (Debug) run shell
Q> Quit
R> Redraw Menu
Choice [1-6,QR]:
To change the settings, type
To quit the configuration without applying the settings, type
CAUTION:
then all the settings are discarded.
(Optional) If you have applied the settings, then type
12.
You are taken to the console login prompt.
The configuration of the appliance as a backup or secondary FMPM node is now complete.
NOTE: After you configure an FMPM node, you must add it to the Junos Space
fabric using the Junos Space Network Management Platform. For more
information, see the Adding a Node to an Existing Junos Space Fabric topic in
the Junos Space Network Management Platform Workspaces Feature Guide
(available at
http://www.juniper.net/techpubs/en_US/release-independent/junos-space/index.html
You can specify the name of the FMPM node when you add the node to the
Junos Space fabric.
From Junos Space Network Management Platform Release 14.1R1 onward, you can
configure the eth1 Ethernet interface as an administrative interface. For the FMPM node,
configure the eth1 interface when the node reboots after the basic configuration is
complete.
Chapter 7: Performing Initial Configuration
. The settings that you configured are applied and a
A
C , and follow the prompts on the CLI.
If you quit the configuration without applying the settings,
.
Q
Q to quit.
).
85