Configuring A Junos Space Appliance As The Secondary Fmpm Node - Juniper JA2500 Junos Space Hardware Manual

Configuring a Junos Space Appliance as the Secondary FMPM Node

Copyright © 2018, Juniper Networks, Inc.
Ensure that the Junos Space Appliance is connected to a management console and
that the management device is powered on.
Ensure that the appliance is booted and displays the login prompt at the console.
Ensure that 100 GB free disk space is available before configuring a node as an FMPM
node.
Ensure that you have the following information available:
IPv4 address and subnet mask for the eth0 Ethernet interface
(Optional) IPv6 address and prefix for the eth0 Ethernet interface
IPv4 address of the default gateway
(Optional) IPv6 address of the default gateway
IPv4 address of the name server
(Optional) IPv6 address of the name server
Virtual IP (VIP) address of the FMPM nodes in IPv4 and IPv6 formats
The VIP address is used for communications between Junos Space nodes and FMPM
nodes. This IP address must be in the same subnet as the IP address assigned to the
eth0 Ethernet interface, and the VIP address must be different from the VIP address
used to access the Web GUI.
(Optional) IPv4 address of the eth1 Ethernet interface
If the IP address of the eth1 interface Is not in the same subnet as the VIP address,
ensure that you have the subnet mask and the default gateway for the eth1 interface.
This topic discusses the following tasks:
Configuring a Junos Space Appliance as the Secondary FMPM Node on page 81
Configuring the eth1 Interface on page 85
You can configure the Junos Space Appliance as the backup or secondary FMPM node.
To configure an appliance as a backup or secondary FMPM node:
At the serial console login prompt, type the default username (
1.
Type the default password (
2.
You are prompted to change your password.
To change the default password, do the following:
3.
Type the default password and press Enter.
a.
Type your new password and press Enter.
b.
Chapter 7: Performing Initial Configuration
) and press Enter.
abc123
) and press Enter.
admin
81