Configuring A Junos Space Appliance As A Junos Space Node - Juniper JA2500 Junos Space Hardware Manual

JA2500 Junos Space Appliance Hardware Guide
Related
Documentation

Configuring a Junos Space Appliance as a Junos Space Node

48
Power on the appliance by toggling the power switch located at the rear panel of the
2.
appliance.
The appliance is shipped with a version of the Junos Space Network Management
Platform software installed. When the appliance is powered on, the serial console
displays diagnostic information before booting. When booting is complete, the serial
console displays the login prompt. You are now ready to configure basic settings on
the appliance.
Connecting a Junos Space Appliance to a Management Console on page 43
Configuring a Junos Space Appliance as a Junos Space Node on page 48
Configuring a Junos Space Appliance as a Standalone or Primary FMPM Node on
page 70
Installing a Junos Space Image on a Junos Space Appliance by Using a USB Drive on
page 96
Powering Off the Junos Space Appliance on page 102
You can configure a Junos Space Appliance as a Junos Space node or as a specialized
node used for fault monitoring and performance monitoring (FMPM). To configure a
Junos Space Appliance as a Junos Space node, you must configure basic network and
system settings to make the appliance accessible on the network.
NOTE:
From Junos Space Network Management Platform Release 14.1R2 onward,
you can configure Junos Space Ethernet interfaces with only IPv4 addresses,
or both IPv4 and IPv6 addresses.
From Junos Space Network Management Platform Release 16.1R1 onward,
you can configure access to Junos Space through a Network Address
Translation (NAT) gateway.
The disk space allocation for a JA2500 Junos Space Appliances is as follows:
1.2 TB for /var
715 GB for
/var/log
92 GB for /tmp
92 GB for
/
Before you begin, do the following:
Ensure that the Junos Space Appliance is connected to a management console and
that the management device is powered on.
Copyright © 2018, Juniper Networks, Inc.