Table of Contents
Advertisement
CHAPTER 14
Connecting the TCX1000-RDM20 to
External Devices
Connecting the TCX1000-RDM20 to a Management Ethernet Device
Copyright © 2019, Juniper Networks, Inc.
Connecting the TCX1000-RDM20 to a Management Ethernet Device on page 79
Connecting the TCX1000-RDM20 to a Management Console on page 80
Connecting the TCX1000-RDM20 to the Network and External Devices on page 81
Installing and Connecting the TCX1000-RDM20 OSC SFP on page 82
You can monitor and manage the TCX1000-RDM20 by using a dedicated management
channel. Use the management port to connect the TCX1000-RDM20 to a network for
out-of-band management.
NOTE:
You cannot use the management port to perform the initial
configuration of the TCX1000-RDM20. You must configure the management
ports through the console connection before you can successfully connect
to the TCX1000-RDM20 using the management ports. See
Initial Configuration for the TCX1000-RDM20" on page
Ensure that you have an appropriate cable available. See
and Management Connections for the TCX1000-RDM20" on page
To connect a TCX1000-RDM20 to a network for out-of-band management (see
Figure 27 on page
80):
Connect one end of the cable to the management port (labeled
1.
the TCX1000-RDM20.
Connect the other end of the cable to the management network device.
2.
"Performing the
86.
"Cable Specifications for Console
55.
DCN 0 or DCN 1
) on
79
Advertisement
Table of Contents
Troubleshooting
