Removing A Tcx1000-2D8Cmd From A Rack - Juniper TCX1000-RDM20 Hardware Manual

Related
Documentation

Removing a TCX1000-2D8CMD from a Rack

Copyright © 2019, Juniper Networks, Inc.
Remove the TCX1000-RDM20 from the rack.
2.
Transport the TCX1000-RDM20 to your desired new location or pack it to prepare to
3.
return (see "Returning a Hardware Component to Juniper Networks, Inc." on page
Mounting a TCX1000-RDM20 in a Rack or Cabinet on page 62
If you need to remove a TCX1000-2D8CMD to return it or relocate an installed
TCX1000-2D8CMD, perform the following procedure.
NOTE: When you remove multiple devices from a rack, remove the device in
the top of the rack first and proceed to remove the rest of the devices from
top to bottom to avoid toppling the rack.
NOTE: This procedure requires two persons. Do not attempt to do it alone.
Before removing a TCX1000-2D8CMD from a rack:
Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed TCX1000-2D8CMD in its new
location and along the path to the new location.
Read "General Electrical Safety Guidelines and Warnings" on page
Instructions Warning" on page
Ensure that you have disconnected any cables or wires attached to the
TCX1000-RDM20 (see "Disconnecting a Fiber-Optic Cable from a TCX1000 Device"
on page 125).
Ensure that you have disconnected any cables or wires attached to the eight channel
ports (C0 to C7 ports) on the TCX1000-2D8CMD (see
Cable from a TCX1000 Device" on page
Ensure that you have the following tool available:
Screwdriver appropriate for your rack-mounting screws.
To remove a TCX1000-2D8CMD from a rack:
159.
"Disconnecting a Fiber-Optic
125).
Chapter 22: Removing the Device
145).
177, and "Installation
131