Removing The Device; Powering Off A Tcx1000-Rdm20 - Juniper TCX1000-RDM20 Hardware Manual

CHAPTER 22

Removing the Device

Powering Off a TCX1000-RDM20

Copyright © 2019, Juniper Networks, Inc.
Powering Off a TCX1000-RDM20 on page 129
Removing a TCX1000-RDM20 from a Rack or Cabinet on page 130
Removing a TCX1000-2D8CMD from a Rack on page 131
NOTE: Use the following procedure to power off a TCX1000-RDM20.
Before you power off a TCX1000-RDM20:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage. See "Prevention of Electrostatic Discharge Damage" on page
Ensure that you do not need to route traffic through the TCX1000-RDM20.
Ensure that you have the following parts and tools available to power off the
TCX1000-RDM20:
An ESD grounding strap
An external management device such as a PC
To power off an TCX1000-RDM20:
Attach an ESD grounding strap to your bare wrist to prevent damage to the equipment
1.
caused by static discharge. Connect the strap to one of the ESD points on the chassis.
Disconnect power to the TCX1000-RDM20:
2.
AC power supply—If the AC power source outlet has a power switch, set it to the
off ( O ) position. If the AC power source outlet does not have a power switch, gently
pull out the male end of the power cord connected to the power source outlet.
DC power supply—Switch the circuit breaker on the panel board that services the
DC circuit to the off position.
178.
129