Table of Contents
Advertisement
TCX1000 Programmable ROADM Hardware Guide
Related
Documentation
Connecting the TCX1000-2D8CMD to a TCX1000-RDM20
110
Figure 45: Installing the TCX1000-2D8CMD in the Chassis
Slide the TCX1000-2D8CMD until it is fully seated in the slot. Push the knobs in fully
4.
on the snap latch (located on either side) to lock in the TCX1000-2D8CMD.
Install additional modules if needed by following the same steps. You can install up
5.
to three modules in the chassis.
TCX1000-2D8CMD Description on page 105
Connecting the TCX1000-2D8CMD to a TCX1000-RDM20 on page 110
The TCX1000-2D8CMD has optical connectors to which you can connect fiber-optic
cables.
Before you connect a fiber-optic cable to a TCX1000-2D8CMD, ensure that you have
taken the necessary precautions for safe handling of lasers. See the
Warnings for Class 1M Juniper Networks Devices" on page
"Laser Safety
167.
Copyright © 2019, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
