Chassis And Component Lifting Guidelines; Ramp Warning - Juniper TCX1000-RDM20 Hardware Manual

TCX1000 Programmable ROADM Hardware Guide
Related
Documentation

Chassis and Component Lifting Guidelines

Ramp Warning

160
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
General Safety Guidelines and Warnings on page 153
Laser and LED Safety Guidelines and Warnings
Laser and LED Safety Guidelines and Warnings for the ACX5000 Router
Before moving the device to a site, ensure that the site meets the power, environmental,
and clearance requirements.
Before lifting or moving the device, disconnect all external cables and wires.
As when lifting any heavy object, ensure that most of the weight is borne by your legs
rather than your back. Keep your knees bent and your back relatively straight. Do not
twist your body as you lift. Balance the load evenly and be sure that your footing is firm.
Use the following lifting guidelines to lift devices and components:
Up to 39.7 lb (18 kg): One person.
39.7 lb (18 kg) to 70.5 lb (32 kg): Two or more people.
70.5 lb (32 kg) to 121.2 lb (55 kg): Three or more people.
Above 121.2 lbs (55 kg): Material handling systems (such as levers, slings, lifts and
so on) must be used. When this is not practical, specially trained persons or systems
must be used (riggers or movers).
WARNING: When installing the device, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Copyright © 2019, Juniper Networks, Inc.