Table of Contents
Advertisement
Installing the TCX1000-2D8CMD in the Chassis
Copyright © 2019, Juniper Networks, Inc.
Have a second person secure the front of the chassis to the rack using four mounting
3.
screws (and cage nuts and washers if your rack requires them). Tighten the screws.
See
Figure 43 on page
109.
Figure 43: Installing the Chassis on a Rack
To install the TCX1000-2D8CMD in the chassis:
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
1.
Remove the blank cover by pulling the knobs of the snap latch (located on either side)
2.
and pulling the cover out. See
Figure 44: Removing the Blank Cover from the Module Slot
Lift the TCX1000-2D8CMD and carefully align it with the slot in the chassis, as shown
3.
in
Figure 45 on page
110.
Chapter 17: Installing and Connecting the TCX1000-2D8CMD Modules
Figure 44 on page
109.
109
Advertisement
Table of Contents
Troubleshooting
