Dynamics Display Function - Yamaha O2R Owner's Manual

1. Press the [DYNAMICS)
button.
The DYNAMICS display
function appears.
2. Select a channel using
the (SEL) buttons.
N ote: Press the (SEL)
button for the STEREO
channel to access the
for the
dynamics processors
output buses.

DYNAMICS Display Function

Dynamics can be applied to the input channels (MIC/LINE 1 through 16,
LINE 17/18 through 23/24), the tape return channels (TAPE 1 through 16),
the internal bus outputs (BUS 1 through 8), and the stereo output. For
stereo channels when the link is on, the dynamics processor is applied
equally to both channels.
Display Screen
Shown below is the DYNAMICS display function:
Similar to the EQUALIZER display function, the DYNAMICS display
function shows the dynamics settings for the currently selected channel
only.
The top of the display contains the Dynamics library icon, the DYNAMICS
icon, the main control prompts (KEY IN, ST.LINK, and optionally IN), the
dynamics graph, and the gain reduction meter plus a level meter for the
currently selected channel pair.
The bottom of the display is split into two main sections:
The first section shows the channel KEY IN settings and LINK icons. These
settings can be changed by the CURSOR buttons, the encoder wheel, and
[ENTER] button.
The second section contains the controls for adjusting the parameters for
the currently selected channel. There are rotary icons for the threshold,
ratio, output gain, attack, release, and so on, depending on which dynamics
program you have selected. Use the CURSOR buttons to select the desired
icon and adjust its value with the encoder wheel. Press the [ENTER] button
to turn the dynamics processor on or off.
Dynamics 69
Digital Recording Console 02R User's Guide