Other Functions; Midi Monitor; Loop Playback - Yamaha QX5 Owner's Manual

Ka
OTHER FUNCTIONS
CLICK
RESET
MIDI MONITOR
LOOP PLAYBACK
Pressing + will turn the metronome on or off at any time. Using
the Setup function (p. 38), you can have the metronome automatically
sound during record and playback. By connecting the back panel Click Out to an
amp/speaker or mixer, you can hear the click through your monitor system or
headphones. When the back panel Click Out is used, the internal click will not
sound.
Pressing + will do the following.
* If pressed during playback, play will stop (just as if you had pressed [STOP]).
* If pressed while transmitting or receiving data (tape or MIDI), transmission or
reception will stop.
* If pressed in Setup, Edit or Load/Save modes, it will return to Tempo, Measure,
Track or Clock mode.
* If pressed while in Tempo, Measure, Track or Clock modes, Song Position will
be reset.
This lets you see on what MIDI channel messages are being received and trans-
mitted. Double-click [MEASURE]. When a message is received or transmitted, the
channel number will be displayed for 0.5 seconds. Press to select Input
or Output monitor.
A message is being Messages are being transmitted
received on ch. 3. on channels 4 and 7.
When Auto Locate is on, press [SHIFT] + [START] during playback. Playback
will continue in a loop between the Auto Locate measure memory (p. 13) and the
point at which you pressed {SHIFT| + [START].
46