Installation; Stop Switch; Wiring Harness - Stihl MS 440 Service Manual

7.3.2

Installation

– Degrease the crankshaft stub
and bore of the flywheel hub with
standard solvent-based
degreasant not containing any
chlorinated or halogenated
hydrocarbons – b 16.
: Ensure that the key (arrow) is
properly seated.
– Fit the flywheel.
– Screw on the collar nut and
tighten it down – b 3.5
Reassemble remaining parts in the
reverse order.
MS 440, MS 440 C
7.4

Stop switch

2 1
– Remove the switch shaft –
b 10.1
– Turn the switch housing until the
slide control is clear.
: Pull out the slide control (1) and
compression spring (2).
: Carefully push the switch
housing aside and remove it.
– When fitting the slide control,
push it inwards until it clicks into
place.
7.5

Wiring harness

1
2
– Remove the ignition module –
b 7.1
: On machines with handle
heating, pull the male
connector (1) out of the female
connector (2).
: Pull the wiring sideways out of
the tank housing
– Remove the carburetor –
b 12.2.1
: Remove the grommet and wiring
from the tank housing.
49