System Variables For The Steps Tab - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.8 Reference list, system variables
Range Enumeration
ARCHIVE
FACTORY
ORIGIN
UNUSED
Enumeration source of the SDB data - SdbSource
Range Enumeration
"System configuration" dialog - SystemConfig
Source of the SDB data enumeration - SdbSource
Up.$Dialog.SystemConfig.SdbSources.
ARCHIVE
ORIGIN
UNUSED
Enumeration source of the DRV data - DrvSource
Range Enumeration
"System configuration" dialog - SystemConfig
Source of the DRV data enumeration - DrvSource
Up.$Dialog.SystemConfig.DrvSources.
ARCHIVE
AUTOMATIC
ORIGIN
TARGET
UNUSED
4.8.4

System variables for the Steps tab

The following system variables are assigned to the Steps (Page 225) tab and are addressed
using the prefix Up.$Step .
384
Type
Enumerator value
Type Change effective
Enumerator value readOnly
Type Change effective
Enumerator value readOnly
Change effective Description
readOnly The data is taken from an archive.
This PLC data is used after a general
reset
The actual PLC data at the time of
package execution is used.
This enumeration value indicates to
the package that this data is not pro‐
cessed.
Description
The data is taken from an archive.
The actual SDB data of the PLC at the
time of the package execution is used.
This enumeration value indicates to
the package that this data is not pro‐
cessed.
Description
The data is taken from an archive.
Data after an automatic device config‐
uration (as for SINUMERIK Operate) is
used.
The actual drive data at the time of
package execution is used.
A SINAMICS offline technology pack‐
age is used.
This enumeration value indicates to
the package that this data is not pro‐
cessed.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE