Ncu/Ppu Access (Configuration) - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.4 Project folder
Dialog view during the package execution (for commissioning engineers / operators)
Execution of the "PCU access" dialog page cannot be deactivated.
If "Data areas > Use PCU" has been selected in the Package tab, this dialog page is executed
automatically when executing a package.
Further information can be found on package execution in the Package execution (Page 405)
section.
Figure 4-18
Buttons for the package execution dialogs
Information on the general buttons in the dialogs can be found at Meaning of buttons
(Page 155).
4.4.2.14

NCU/PPU access (configuration)

This dialog page enables access to the NCU in the case of SINUMERIK 840D sl or the PPU
in the case of SINUMERIK 828D. This specifies with which control and which login data the
package should be connected for the execution.
168
PCU access - commissioning engineer / operator view
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE