System Variables - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.6 Script language
Up.doVar.doType
4.6.15.3

System variables

Note
When the password variables are used, the password that is used appears in the logbook
during the package execution.
System variables Up.$<Sysname>
System variables are package variables that provide information on the package configuration
and runtime environment. System variables are identified by a '$' prefixed to the name
<Sysname>.
System variables are assigned as follows:
● Up.$Pack - "Package" tab (Page 368)
● Up.$Dialog - "Dialogs" tab (Page 372)
● Up.$Step[ID] - "Steps" tab (Page 384)
● UP.$Env - System variables for the environment (Page 391)
Note
A reference list for system variables can be found in the Reference list system variables
(Page 368) section.
338
Supplies the type of the drive object.
Possible values lie between 0 and 600. The valid values correspond to the values set in
SINAMICS at the Control Unit in parameter "drive objects type / DO type" P0107.
Examples
Possible values for "Up.doVar.doType" are:
● The value 3 corresponds to DO type "SINAMICS I".
● The value 4 corresponds to DO type "SINAMICS NX/CX32".
● The value 10 corresponds to DO type "ACTIVE INFEED CONTROL".
● The value 11 corresponds to DO type "SERVO".
● The value 254 corresponds to DO type "CU-LINK".
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE