Figure 14-13
Note
If the correction path has not been traversed in full and the NC/PLC interface signal
DB31, ... DBX31.7 (reset synchronism correction) has not been reset, writing to variable
$AA_COUP_CORR[S<n>] will not have any effect.
14.5.13.7
Limitations and constraints
Several following spindles
If a leading spindle has several following spindles, each of these following spindles can be
processed with the axial NC/PLC interface signal DB31, ... DBX31.6 (track synchronism)
separately from one another.
Writing variable $AA_COUP_CORR
System variable $AA_COUP_CORR is only written from the part program or synchronized
actions when a generic machine coupling has been activated for the corresponding axis/
spindle at least once.
Axes and spindles
Function Manual, 06/2019, A5E47437747B AA
Time diagram for synchronizing and resetting synchronism correction
M3: Coupled axes
14.5 Generic coupling
565