Extended Example With Non-Linear Components - Siemens SINUMERIK 840D Function Manual

Mc axes and spindles

Hide thumbs Also See for SINUMERIK 840D:

Table of Contents

M3: Coupled axes

14.4 Electronic gear (EG)

Extended example with non-linear components

Introduction

The following example extends the example (see "Figure 14-10 Definition of axes on a gear

hobbing machine (example) (Page 483)") with the following:

● Machine error compensations which are not linearly dependent on the Z axis, and

● a Z-axis dependent component with tooth geometry.

This can be used to create a slightly convex tooth surface, so that the center of the tooth is

stressed more than the edges during operation.

Figure 14-11

Extended example with non-linear machine fault compensation and non-linear components on the tooth

Axes and spindles

Function Manual, 06/2019, A5E47437747B AA

Sinumerik 840d sl