JUKI AMS-221EN Series Engineer's Manual page 127

E
F
G
D
H
I
J
K
L
– 123 –
In the simplified program editing screen, the editing step
is selected with the use of the step forwarding button
(D) and the step return button
selected step, it is possible to carry out command port I/
O setting and parameter setting.
A maximum of 99 steps can be entered.
1) Command selection
When the command selection button
pressed on the simplified program editing screen,
the command selection screen is displayed.
The command that is being selected is displayed on
the button.
On the command selection screen, the command
button (G) is displayed. Press the selecting command
button and then press the Enter button
In regard to command descriptions, refer to (4) list of
simplified program commands.
2) Port I/O information setup
The port status can be set up for the four items as
specified below.
(I) Output information (High) setup button
(J) Output information (Low) setup button
(K) Input information (High) setup button
(L) Input information (Low) setup button
When the setting button is pressed, the I/O data se-
lection screen is displayed.
(E). For each
(F) is
(H).