JUKI AMS-221EN Series Engineer's Manual page 110

(2) External input terminal setup
The input terminal numbers to be used for the bank function are set up.
B
C
1) Bank function setup screen display
When the number of
terminals is preset for the memory switch data (Level
2), the bank function button
the mode changeover screen. When this button is
pressed, the bank function setup screen is displayed.
A
2) Registration of the direct pattern number
When the direct pattern number registration button
ber (B), the direct pattern number selection screen is
displayed. However, the selectable direct pattern num-
bers are limited only for the individual sewing. The
direct pattern number to be registered for the input
terminal is selected as indicated by (D).
3) Bank function setup
E
The bank function can be set up through changeover
operation of the bank function setup button
D
– 106 –
K130
(C) is pressed for a setting input terminal num-
: Bank function turned ON
: Bank function turned OFF
bank connection select
(A) is displayed on
(E).