At Unit Connection / Disconnection - JUKI AMS-221EN Series Engineer's Manual

(24) AT unit connection / disconnection

1. Remove the setscrew
to "Second thread tension connection / disconnection.")
2. Draw out the cotter pin
not to drop the washer
3. Lift the AT joint block
type) of the AT link unit (rear)
4. Draw out the AT link unit (front)
5. Remove the 2 setscrews
6. For reassembly, follow the steps of 5. to 1. above.
Procedures of disassembling
of the AT link unit (front)
from the pin block (H type) or
at that time.
of the AT unit upward to remove the block from the pin block
.
from the plane side (in the direction of the arrow
and take out the AT solenoid unit
F
and take out the second thread tension
(S type) of the AT link unit (rear)
.
E
Close contact
– 38 –
. ((24) Refer
. Be careful
(H type ) or (S
) and remove it.
E