JUKI AMS-221EN Series Engineer's Manual page 114

Output No. Contents
70 Bobbin status
71 Main unit input status
72 Pattern check status
73 Last mode status
74 Presser SW input effective
75 Start SW input effective
76 Temporary stop SW turned OFF Temporary stop switch error (E050) being displayed (E050). OFF by reset.
77 Thread breakage error OFF
78 Air pressure being lowered
79 Other errors being present
80 Sewing counter carryover
81 Sheet counter carryover
For the trigger
97 READY operation start
98 READY operation end
99 Sewing start
100 Before sewing start point reset
101 After sewing start point reset
102 Before sewing machine start
103 After sewing machine stop
104 Before jump feed start
105 Before origin reset start
106 Before total presser lowering
107 Before total presser lifting
Bobbin key → Bobbin status
Main unit input key → Main unit input status
Pattern check, thread tension / intermediate presser height command setup
Last mode status (Sewing machine revolutions / output / XY / presser thread cutter / thread
clamp / intermediate presser test mode)
When the presser switch input is effective
When the start switch input is effective
Thread breakage error (E052) being displayed. OFF by reset.
Air pressure low error (E031) being displayed. OFF by reset.
Errors other than 76 to 78 being displayed. OFF by reset.
Sewing counter carryover being displayed. OFF by counter reset.
Sheet counter carryover being displayed. OFF by counter reset.
When the READY key is accepted. ON for 100ms.
After moving to (READY key →) sewing start point. ON for 100ms.
When the Start switch is accepted. (Normal / Midway stop / Temporary stop). ON for 100ms.
Before sewing start point reset (after pattern data end). ON for 100ms. Origin reset not
included.
After sewing start point reset (before feeding frame lifting). ON for 100ms. Origin reset in-
cluded.
Before sewing machine head driving (before feeding frame lowering). ON for 100ms.
After sewing machine head stop (after wiper and before feeding lifting). ON for 100ms.
Jump feed operation / Feed forward / Return operation. ON for 100ms.
When the origin reset key is accepted. ON for 100ms.
At the time of total presser lowering (Ready, threading, bobbin, etc.). ON for 100ms.
At the time of total presser lifting (Ready, threading, bobbin, etc.). ON for 100ms.
– 110 –
Explanation