(37) Adjustment of the pressure reducer
Standard adjusting value of the pressure reducer for the presser cylinder (left)
1. Loosen the nut
Then, tighten the nut
Standard adjusting value of the pressure reducer for the presser cylinder (right)
1. Loosen the nut
presser cylinder (right) can rise at the same time. Then, tighten the nut
2. At that time, confirm that the pressure reducer of
to 0.10 to 0.17Mpa. If the pressure seems to deviate from this range, check the torque at the working section
of the feed bracket and readjust this deviation.
(Caution) For Type S (specification for united presser), only the pressure reducer of
cylinder (right) is available. Adjust the pressure reducer of
until its pressure is reduced to 0.13 to 0.15Mpa.
Standard Adjustment
and turn the knob
to adjust the air pressure so that it is reduced to 0.13 to 0.15Mpa.
.
and turn the knob
to adjust so that
B
A
for the presser cylinder (left) and
for the presser cylinder (right) has reduced the pressure
0.13 to 0.15Mpa
For 2-step stroke cylinder
– 58 –
.
for the presser
for the presser cylinder (right)
for the