Headphones Operation; Controls - Jeep Grand Cherokee 2013 Operating Information Manual

Headphones Operation

The headphones receive two separate chan-
nels of audio using an infrared transmitter from
the video screen.
Front seat occupants receive some headphone
audio coverage to allow them to adjust the
headphone volume for the young rear seat
occupants that may not be able to do so for
themselves.
If no audio is heard after increasing the volume
control, verify that the screen is turned on and in
the down position and that the channel is not
muted and the headphone channel selector
switch is on the desired channel. If audio is still
not heard, check that fully charged batteries are
installed in the headphones.
200
1. Volume Control
2. Power Button
3. Channel Selection Switch
4. Power Indicator

Controls

The headphone power indicator and controls
are located on the right ear cup.
NOTE:
The rear video system must be turned on
before sound can be heard from the head-
phones. To conserve battery life, the head-
phones will automatically turn off approxi-
mately three minutes after the rear video
system is turned off.
Changing the Audio Mode for Headphones
1. Ensure the Remote Control channel/screen
selector switch is in the same position as the
headphone selector switch.
NOTE:
• When both switches are on Channel 1, the
Remote is controlling Channel 1 and the
headphones are tuned to the audio of the
VES™ Channel 1.
• When both switches are on Channel 2, the
Remote is controlling Channel 2 and the
headphones are tuned to the audio of the
VES™ Channel 2.
2. Press the MODE button on the remote control.
3. If the video screen is displaying a video
source (such as a DVD Video), pressing STA-
TUS shows the status on a popup banner at the
bottom of the screen. Pressing the MODE but-
ton will advance to the next mode. When the
mode is in an audio only source (such as FM),
the Mode Selection menu appears on screen.